Removing-refitting

Removing-refitting

Proceed as follows to remove the throttle body:

• remove the collars indicated (arrowed), then unscrew both bolts (detail) and remove the intake sleeve with resonator;
• release the accelerator cable terminal from lever (A), then remove the adjustment block from bracket (B) and place the accelerator cable aside;
• disconnect the engine idle speed actuator connector (1);
• unscrew the four retaining bolts (arrowed) and remove the throttle body.

Reverse removal instructions to refit.

Adjust the accelerator cable as described in the following paragraph.

NOTE If the throttle body is replaced, connect a tester (Examiner) to the tester connection and run the required procedure to zero and self-learn engine idle adjustment actuator (M.D.S.) data