Removing the test equipment

Removing the test equipment

Remove the test equipment 1860955000 with the key in the OFF position, following these instructions:

• introduce the end of the pipe connected to the valve (c) into a suitable container;
• open the valve (c) and drain the excess fuel into the container;
• keep the pipe in the container and disconnect the end of the supply pipe from the female connector for the adaptor (A) keeping the connection upwards;
• let the fuel in the pipes flow into the container;
• disconnect the end of the adaptor (B) from the rapid connector and let the residual fuel flpw from the pipes into the container;
• reconnect the fuel supply pipe.

Checking fuel consumption using FLOWTRONIC equipment 1866149001

To carry out the check, the equipment should be configured with the connectors shown in the diagrams:

A. supply pipe side
B. fuel manifold side

If this has not been done, make the adjustment following the instructions given below:

• cut the end of the FLOWTRONIC equipment inlet pipe and replace it with a female rapid connector (1), contained in the Kit No. 1860955003, as illustrated in figure A;

• cut the end of the FLOWTRONIC equipment outlet pipe and replace it with a male connector (2), contained in the Kit No. 1860955003, as illustrated in figure B.

The connectors removed should be recovered and kept for any future connections.