Removing-refitting

Removing-refitting

Disconnect the accelerator cable as follows:

• working from inside the vehicle (A), disconnect the control cable from its anchorage on accelerator pedal (B);
• turn the accelerator lever to disengage the accelerator cable terminal from lever (C). Then remove the adjustment block from bracket (D) and move the accelerator cable aside.

Reverse removal instructions to refit.

ENGINE IDLE ADJUSTMENT ACTUATOR/THROTTLE POSITION SENSOR

NOTE The engine idle adjustment actuator/throttle position sensor should be disconnected from the throttle body only in case of replacement because removing/refitting causes damage to certain components (e.g. internal sealing rings) and correct component operation cannot be guaranteed once the component is refitted.

Removing-refitting

To remove the actuator, disconnect the connector and unscrew the retaining bolts (arrowed).

NOTE It is compulsory to zero and self-learn engine idle adjustment actuator (M.D.S) data as described in the "THROTTLE BODY" paragraph.