Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)02 · 10 Engine
02 · Engine

Removing-refitting (page 3 of 3)

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Removing-refitting (1370 12v)
10 EngineRemoving-refitting · page 3 of 3
Diagram showing the first exhaust pipe section connected to the manifold with retaining nuts and a clamp.
Diagram showing the connection between the first exhaust pipe section and the catalytic converter, including the lambda probe connector.
Upper diagram shows a steering link head being removed from a pillar using an extractor tool. Lower diagram shows the extractor tool (part number 1847038000) in use on the steering linkage.
  1. Remove nuts retaining first exhaust pipe section to manifold.
  2. Unscrew the bolts fastening first exhaust pipe section to catalytic converter, disconnect the lambda probe connector and then remove the piping.
  3. Remove the nut retaining the steering link head to the pillar (gearbox end), then remove the head using extractor 1847038000.
  4. Remove the bolts retaining the damper to the pillar (gearbox end), then turn pillar forward to release brake pipes from fastenings on damper.
  5. Remove plastic guard shown in figure from right wheel arch by undoing screws (1) and retaining stud (2). Then disconnect steering link head from pillar and bolts retaining damper to pillar (timing end), as described for gearbox end.
Diagram showing the bolts retaining the damper to the pillar at the timing end.
Diagram of the right wheel arch area showing a plastic guard secured by screws labeled (1) and a retaining stud labeled (2).

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.