Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)02 · 10 Engine
02 · Engine

Removing-refitting power unit

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Removing-refitting (1581 16v) › Removing-refitting power unit
10 EngineRemoving-refitting power unit · page 1 of 5
Diagram showing the air shroud and retaining screws on the front beam
Diagram showing coolant sleeves connected to the expansion tank

REMOVING-REFITTING POWER UNIT

Position vehicle on lift, remove front wheels and disconnect battery negative terminal, then proceed as follows:

  1. Remove the air shroud by undoing the screws shown in the figure, which retain the unit to the front beam.
  2. Position a suitable container to recover the coolant and remove sleeves shown in the figure, which carry coolant to and from the expansion tank.
  3. Remove the air intake duct by undoing the clips shown in the figure, then remove from engine bay together with oil vapour recovery line.
  4. Lift battery positive terminal protective cover and disconnect lead. Unscrew nut retaining battery to holder, then remove from engine bay with battery holder guard.
Diagram showing the air intake duct and clips in the engine bay
Diagram showing the battery, positive terminal cover, and retaining nut

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.