Components of clutch pedal (page 3 of 3)

1. Release the injection wiring bundle from the retaining clip to allow access to the fitting of the pipe connected to the slave cylinder on the clutch pump.
2. Disconnect the fitting of the pipe connecting clutch pump - slave cylinder.
3. Working from inside the car, remove the roll pin retaining the clutch pump rod to the pedal.
4. Unscrew the nuts retaining the clutch pump to the body take out slightly in order to release the rod from the clutch pedal, then remove complete with connection pipe leading to the reservoir.
5. Working on the bench, separate the clutch pump from the pipe connected to the reservoir.

Reverse disassembly instrutions to assemble. To refit the pump connec-tion line to the reservoir, first position the rubber fitting over the hole in the body, and then thread the pipe from inside the car into the engine bay.