Brake-clutch fluid reservoir

BRAKE-CLUTCH FLUID RESERVOIR

Removing-refitting

1. Remove the upper cam cover protection.
2. Release the diesel lines from the retaining clip, then remove the trim shown in the figure by undoing the retaining bolts.
3. Disconnect fluid level sensor connector and remove the reservoir cap, then drain the brake fluid from the reservoir using a syringe.
4. Disconnect the hydraulic clutch line from the reservoir, then separate the reservoir from the brake pump and lift out.

Ensure fluid remaining in the reservoir does not leak out.

NOTE Carry out brake and clutch fluid reservoir removal operations in reverse order to refit.

Ensure the reservoir is extremely clean before filling.

Bleeding hydraulic brake and clutch system