Hydraulic operation

Hydraulic operation

REMOVING-REFITTING BRAKE PUMP

Proceed as follows to remove the brake pump:

1. Disconnect the pipe connecting air cleaner to butterfly valve cause by undoing the fastenings indicated in figure.
2. Remove the relay cover.
3. Remove the relay bracket by undoing the bolts retaining it to the body, disconnect connector indicated and move the bracket to one side.
4. Remove the retaining stud of the lining of the bulkhead between lining to one side.
5. Remove the cap from the brake and clutch fluid reservoir after disconnecting the fluid level sensor connector. Then drain the fluid from the reservoir.