05 · General

Refitting

Make: Fiat
Model: Bravo /Brava (182) Factory Service Manual
Year: 1995–2001
Section: Hydraulic operation (99 range) › Refitting

‹ Prev Next › Dismantling pedal assembly at the bench

33 Braking systemRefitting

Diagram showing the brake servo and pedal unit assembly with callout number 1

Close-up diagram of the brake servo pushrod connection point with callout number 2

Diagram illustrating the separation of the brake servo from the pedal unit, with arrows indicating movement directions

1. Separate the brake servo from the pedal unit by releasing the brake servo rod from the transmission on the control pedal.

Refitting

2. Reverse removal instructions to refit. Take care to position the control rod and washer in their correct place on the brake servo, to ensure that they do not come out of place when fitting the brake pump.

REMOVING-REFITTING PEDAL UNIT

Proceed as described for the brake servo removal to remove the pedal unit. Note that the brake pump need not be removed from the brake servo and vacuum intake pipe. Before removing the pedal assembly, unscrew the nuts retaining the brake servo to the pedal mount as shown in the figure.

Diagram showing the nuts retaining the brake servo to the pedal mount, indicated by arrows

3. Unscrew nuts retaining the brake servo to the pedal mount and remove the roll pin securing the brake servo rod to the brake pedal transmission. 4. Undo nuts securing the pedal mount and remove from the car after releasing the brake servo rod from the transmission on the control pedal.

‹ Prev Next › Dismantling pedal assembly at the bench

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.