Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)05 · 33 Braking system
05 · General

Removing-refitting servo brake

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Hydraulic operation (99 range) › Removing-refitting servo brake
33 Braking systemRemoving-refitting servo brake · page 1 of 2
Illustrates engine coolant hose connection and clamp removal
Engine bay showing the upper cam cover with FIAT logo and surrounding components
Engine bay area showing diesel lines, trim, and bulkhead lining near the cabin

REMOVING-REFITTING SERVO BRAKE

  1. Remove the upper cam cover protection.
  2. Release the diesel lines from the retaining clip, then remove the trim shown in the figure by undoing the retaining bolts.
  3. Unscrew bolts retaining the diesel line retaining bracket.
  4. Disconnect the brake and clutch fluid level sensor, then remove the stud retaining the lining of the bulkhead between engine bay and cabin, then move the lining to one side.
  5. Unscrew the bolts fastening the diesel filter bracket, disconnect the connections shown and position the bracket to one side.
Close-up of the brake and clutch fluid level sensor and diesel line connections being disconnected
Diesel filter bracket and its mounting bolts being removed from the engine bay

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.