Removing-refitting servo brake

REMOVING-REFITTING SERVO BRAKE

On right hand drive vehicles, the brake servo is positioned inside the cabin under the pedal unit. To take out, remove the facia trim as described in Section 70, then proceed as follows.

1. Working from the engine bay, remove the sleeve connecting air cleaner and butterfly valve case.
2. Remove the protective relay cover located on the bulkhead between engine and cabin, undoing the bolt indicated.
3. Remove the relay bracket by undoing the bolts retaining it to the body, disconnect connector indicated and move the bracket to one side.
4. Remove the retaining stud and move the lining of the bulkhead between engine bay and cabin to one side.
5. Undo both nuts retaining the brake pump to the brake servo.