Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)10 · 70 Bodywork
10 · Body & interior

Dismantling-fitting front seat covers

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Seats › Dismantling-fitting front seat covers
70 BodyworkDismantling-fitting front seat covers · page 1 of 2
Diagram showing the front seat exterior trim with labels A, B, C, and D indicating the cap, adjustment knob, bolts, and trim respectively.

DISMANTLING-FITTING FRONT SEAT COVERS

Operation sequence

Remove the seat assembly from the car, then proceed as follows:

  1. Remove cap A and squab adjustment knob B. Unscrew bolts C retaining exterior trim D, then remove.
Diagram showing the removal of interior trim and plastic moulding from the rear of the seat, with labels A, B, C, and D indicating screw, trim, cap, and washer.
  1. Unscrew screw A retaining interior trim B. Remove trim B to remove washer D. Take care not to break. Push cap C out from the inside after removing the trim. Recover washer D.
  2. Take off the plastic moulding from the rear as shown in the figure.
  3. Remove plastic moulding B, beginning at the rear side. Release with the aid of a screwdriver, then remove the cushion.
Two diagrams showing the dismantling of the seat cushion: left image shows the removal of a component labeled A, right image shows the release of a component labeled B from the seat frame.

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.