STEERING ANGLE SENSOR - R.R.

Operation 3350E20 · VEHICLE DIRECTION CONTROL SYSTEM VDC/ESP

1.8, 1.9 JTD 8v · ABS

Removing

The steering angle sensor fitted on the power assisted steering box is present on versions with ABS without ESP

- Position the vehicle on a lift.

- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

1. Disconnect the electrical connection from the steering angle sensor.

2. Undo the bolts (2a) and remove the steering angle sensor (2b) from the power assisted steering box.

Refitting

- Place the steering angle sensor back in its housing and secure it tightening the bolts to the recommended torque.

- Connect the electrical connection to the steering angle sensor.

- Connect the negative battery terminal.

- Remove the vehicle from the lift.

ESP

- The steering angle sensor is built into the steering wheel stalk unit and cannot be dismantled individually. Refer to

Op. 5550A13 TORQUE UNIT ASSEMBLY - R&R FOR VERSIONS WITH ESP