Check timing sensor operation
- Make
- Fiat
- Model
- Croma Factory Service Manual
- Year
- 2005–2010
- Section
- Engine ignition › Check timing sensor operation
CHECK TIMING SENSOR OPERATION
| STEP | CHECK TO BE PERFORMED | RESOLUTION IF THE CHECK IS NOT OK |
|---|---|---|
| 1 | Turn the ignition key OFF. Disconnect the cable loom connector from the timing sensor Turn the ignition key ON. Check that the voltage between pin 1 of the sensor and earth is between 4.8 and 5.2 V | Repair or if necessary replace the electrical wiring between the timing sensor and the engine management control unit |
| 2 | Check that the voltage between pin 1 and 3 of the sensor is between 4.8 and 5.2 V Move on to Step 4 | Move on to Step 3 |
| 3 | Repair any faults in the wiring between the engine management control unit and the timing sensor See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT The test can be considered over | Replace the engine management control unit |
| 4 | Check that the voltage between pin 2 of the sensor and earth is between 4.8 and 5.2 V | Move on to Step 3 |
| 5 | Check for faults in the timing sensor, such as intermittent contacts, missing teeth, reference point or incorrect gap | Restore correct operation. Replace the timing sensor if necessary |
| 6 | Replace the timing sensor Op. 1060G22 CAM ANGLE SENSOR - R.R and check the fault has disappeared. The test can be considered over | Repair the original timing sensor and replace the engine management control unit. |
Parts & tools for this job For 2005 Fiat Croma
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.