ENGINE RPM SENSOR - R+R

Operation 5510C26 · COIL, ECU, SENSORS

2.2

Removing

- Position the vehicle on a lift.

- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

1. Disconnect the electrical connection from the engine rpm sensor.

2. Undo the bolt (2a) and remove the engine rpm sensor (2b) complete with seal.

Refitting

- Place the engien rpm sensor back in its housing complete with a new seal and secure it tightening the bolt to the recommended torque.

- Connect the electrical connection to the engine rpm sensor.

- Connect the negative battery terminal.

- Remove the vehicle from the lift.

1.8

Removing

Op. 5520B10 STARTER MOTOR - R+R

1. Disconnect the electrical connection for the engine rpm sensor.

2. Working via the opening in the engine block, undo the bolt (2a) and remove the rpm sensor (2b).

Refitting

- Position the rpm sensor in its housing and secure it using the bolt.

- Connect the electrical connection for the engine rpm sensor.

Op. 5520B10 STARTER MOTOR - R+R