Engine RPM SENSOR - R.R.

Operation 1060G20 · Pressure pump electric control

Removing

Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal.

Carry out - 7055B54 under-engine guard - r r.

1. Disconnect the electrical connection for the rpm sensor.

2. Undo the bolt (2a) and remove the engine rpm sensor (2b).

Removing

Position the vehicle on the ramp.

Ensure that the ignition key is in the stop position, then disconnect the battery negative terminal.

Proceed with the removal - 7055B54 under-engine guard - r r.

1. Disconnect the electrical connection for the rpm sensor.

Refitting

1. Place the rpm sensor (1a) in its seating and secure it tightening the bolt (1b) to the specified torque.

2. Connect the electrical connection for the rpm sensor.

1. Undo bolt (1a) and remove rpm sensor (1b).

Carry out - 7055B54 under-engine guard - r r.

Connect the battery negative terminal.

Refitting

Replace the rear wheel rpm sensor in its housing and fix it using the bolt.

Connect the electrical connection for the rpm sensor.

Proceed with the refitting - 7055B54 under-engine guard - r r.

Connect the battery terminal (-).

Remove the car from the ramp.