LINKAGE SUPPORTS AND IDLERS - R+R

Operation 3380A40 · HANDBRAKE CONTROL AND LINKAGE

2.0 16V

Removing

- Position the vehicle on the lift.

Op. 1042E60 CNG CYLINDER UNIT PROTECTION SEAL - R R

1. Loosen the handbrake cable (1a) and remove the split pin (1b), then release the handbrake cable (1c).

2. Undo the retaining bolts (2a) and remove mounting (2b).

All versions

Refitting

- Fit the handbrake linkage rear idler and, using a new riveter and new rivets, fasten it to the bodyshell.

- Connect the handbrake cable to the idler.

- Connect the section of the handbrake cable with the rear brakes to the idler.

- Fit the handbrake linkage front idler and, using a new riveter and new rivets, fasten it to the bodyshell.

- Connect the handbrake cable to the idler.

- Connect the section of the handbrake cable with the rear brakes to the idler.

- Fit the heat shield and fasten it to the bodyshell using the fixing bolts.

Op. 1076B20 REAR EXHAUST SILENCER - R + R

- Fit the handbrake cable mouting and tighten the fixing bolts.

- Position the handbrake cable and connect the two sections positioning the split pin.

Op. 1042E60 CNG CYLINDER UNIT PROTECTION SEAL - R R

- Proceed with the adjustment of the handbrake cable.

Op. 3380A04 HANDBRAKE - CHECK TRAVEL

- Remove the vehicle from the lift.

Op. 1076B20 REAR EXHAUST SILENCER - R + R

1. Undo the fastening bolts (1a) and remove the heat shield (1b) for the exhaust pipe.

1. Disconnect the handbrake cable from the rear brakes.

2. Disconnect the handbrake cable from the idler.

3. Using a drill with a suitable helical point, remove the fixing rivets.

4. Remove the linkage rear idler.

1. Disconnect the handbrake cable from the rear brakes.

2. Disconnect the handbrake cable from the idler.

3. Using a drill with a suitable helical point, remove the fixing rivets.

4. Remove the linkage rear idler.