VALVE TAPPETS - CHECK AND ADJUST CLEARANCE

Operation 1036H10 · TAPPETS AND ROCKER SHAFTS

2.0 16V

Op. 1048A31 RIGID PIPE CONNECTING AIR CLEANER TO INLET MANIFOLD RIGID PIPE R R

See in Op. 1016A20

See in Op. 1036H14

- If the clearance does not correspond to the recommended figure, carry out the adjustment.

See in Op. 1036B10

1. Remove the tappets.

2. Remove a calibrated pad and measure its thickness.

- Determine the difference between the clearance measured and the recommended clearance for that pad.

- Determine the thickness of the pad to be used by adding the thickness of the current pad to the difference measured.

- Repeat the procedure for all the calibrated pads.

- Fit the tappets in the housing.

See in Op. 1036B10

- Proceed with the refitting

See in Op. 1016A20

Op. 1048A31 RIGID PIPE CONNECTING AIR CLEANER TO INLET MANIFOLD RIGID PIPE R R

2.0 16V, 2.8 JTD 8V

See in Op. 1016A10

See in Op. 1016A20

Op. 4450B04 RIGHT FRONT WHEEL R R

See in Op. 1036H14

1. Lower the tappet in question using a suitable tool.

2. Fit the tool for keeping the tappet lowered, then remove the pressure lever positioned previously.

3. Remove the valve clearanance adjustment plate and replace it with a one of a suitable thickness.

- Remove the tool for keeping the tappet lowered.

- Continue, repeating the procedure described for the remaining valves.

See in Op. 1036H14

Op. 4450B04 RIGHT FRONT WHEEL R R

See in Op. 1016A20

See in Op. 1016A10