HANDBRAKE - ADJUST TRAVEL

Operation 3380A04 · HANDBRAKE CONTROL AND LINKAGE

The adjustment of the parking brake should only be carried out after having replaced: rear brake pads, rear brake shoes, rear brake cylinder, cable assemblies, because the recovery of the clearance due to wear is automatic.

- Position the vehicle on a lift.

Op. 7040L22 REAR COVER ON TUNNEL - R.R.

1. Mark the position of the nut, then loosen the handbrake cable adjustment nut by at least two or three turns to ensure the cable is completely slack.

- Start up the engine and operate the brake pedal at least ten times energetically.

- Place the handbrake lever in the fifth notch on the toothed sector.

- Tighten the adjustment nut on the handbrake lever until the rear wheels are not braked.

- Check that the wheels are free to turn with the lever in the rest position.

- Switch off the engine.

Op. 7040L22 REAR COVER ON TUNNEL - R.R.

- Remove the vehicle from the lift.