Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Grande Punto Factory Service Manual (2005-2012)12 · Brakes
12 · Brakes

Introduction - handbrake

Make
Fiat
Model
Grande Punto Factory Service Manual
Year
2005–2012
Section
Handbrake › Introduction - handbrake
BrakesIntroduction - handbrake

INTRODUCTION - HANDBRAKE

CONSTRUCTION SPECIFICATIONS

The mechanically operated handbrake comprises a lever, located between the two front seats, that activates a compensator to which two flexible rods connected to the parking brake levers on the rear brakes is fitted.

There is a protective boot that prevents water and dirt fromt getting inside the vehicle on the opening between the passenger compartment and the underbody for the compensator operating rod.

Parts & tools for this job For 2005 Fiat Grande Punto

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.