Rear suspension
- Make
- Fiat
- Model
- Scudo Factory Service Manual
- Year
- 1996–2006
- Section
- Technical data (1997 16v) › Rear suspension
00 Introduction and technical dataRear suspension · page 1 of 2
Rear suspension
Rear suspension independent with coil springs.
Cast iron suspension arms on bearings.
Anti-roll bar
Rubber buffers.
| Coil springs | [1997] 16V CF3 | |
|---|---|---|
| Order number | N.A. | |
| Wire diameter | mm | N.A. |
| Number of effective coils | N.A. | |
| Coil direction | N.A. | |
| Released spring height | mm | N.A. |
| Height under a load of: | daN mm | N.A. |
| Spring are divided into two categories, identified by markings yellow (1) springs are loaded to: |
daN a height of mm | – |
| green (1) springs are loaded to: |
daN a height of mm | – |
(1) Springs of the same type must be fitted.
Dampers
| Type, telescopic double-acting | hydraulic | |
| Order number | 9632349580 | |
| Travel (beginning of damping) | mm | 125 |
| Maximum extension | mm | 374 |
Parts & tools for this job For 1996 Fiat Scudo
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTRear shock absorbersSearch: Fiat Scudo 1996 rear shock absorbers
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.