10 EngineRefitting · page 3 of 4
(Cont. Op. 1004B10)
- Connect the starter motor electrical connection
| Name | Connector |
|---|
| Starter motor | A20 |
- Insert the coolant pipe on the water pump.
- Insert the coolant pipe on the thermostat.
- Insert the coolant pipe on the throttle case.
- Restore the electrical connection to the ignition coils
| Name | Connector |
|---|
| Ignition coil N° 1 (cyl. 1-4) | A30 |
| Ignition coil N° 2 (cyl. 2-3) | A30 |
- Connect the electrical connection to the engine temperature sensor
| Name | Connector |
|---|
| Engine temperature sensor | K45 |
- Connect the earth cable on the engine.
| Name | Connector |
|---|
| Earth on engine | C40 |
- Restore the electrical connection to the single injector (SPI)
| Name | Connector |
|---|
| Single-injector (SPI) | N71 |
- Connect the idle regulation actuator electrical connection.
| Name | Connector |
|---|
| Idle actuator | N74 |
- Connect the intake air temperature sensor electrical connection
| Name | Connector |
|---|
| Air temperature sensor | K42 |
- Connect the throttle position sensor electrical connection
| Name | Connector |
|---|
| Throttle position sensor | K56 |
- Insert the brake servo vacuum intake pipe.
- Insert the vacuum intake pipe of the fuel vapours cut-off solenoid valve on the throttle case.
- Insert the absolute pressure sensor pipe on the throttle case.
- Insert the coolant pipe on the thermostat.
- Insert the fuel recycling pipe on the throttle case.
- Insert the fuel inlet pipe on the throttle case.
- Connect the accelerator control hose to the throttle case.
- Complete with Op. 1068A10 ACCELERATOR PEDAL CONTROL -Check, adjustment if necessary and lubrication.
- Connect the lambda sensor electrical connection
| Name | Connector |
|---|
| Lambda sensor | K40 |
- Fit the lambda sensor cable in the mountings on the body.
- Insert the ends of the gear engagement flexible pipes.
- Insert the gear engagement flexible pipe sheath clamps.
- Electrically connect the reversing lights switch
| Name | Connector |
|---|
| Reversing lights switch | I20 |
- Connect the clutch release control hose to the thrust bearing control levers.
- Complete with Op. 1820A14 CLUTCH PEDAL - Stroke adjustment.
- Assemble the air filter support and fasten with its screws.
- Assemble the complete air filter group and throttle case air conveyor.
- Fit the absolute pressure sensor pipe.
- Tighten the nut fastening the air filter to the support.
- Tighten the throttle case air conveyor screws.
- Insert the vacuum intake pipe on the throttle case.
- Insert the oil vapours recovery pipe on the tappets cover.
- Insert the hot air intake sleeve on the discharge manifold.
- Raise the car.
- Connect the lower engine coolant outlet sleeve to the radiator.
- Assemble the engine compartment protection and fasten with its screws.
- Assemble the right supplementary wheel housing (see Op. 7055B42 SUPPLEMENTARY WHEEL HOUSING (one) - R+R.).
(Cont.)
02 Engine
