Refitting

(Op. 5520B12 continued)

2. Remove the fastening nut and disconnect the electric wire leading from the ignition block.

1. Remove the two screws (1a) fastening the starter motor (1b) to the gearbox. Remove the starter motor.

Refitting

• Position the starter motor and screw the two screws fastening it to the gearbox
• Connect the electric wire leading from the ignition block to the starter motor and screw the fastening nut.
• Connect the electric wire leading from the battery t to the starter motor and screw the fastening nut.

• Complete with Op. 5040A28 - AIR CONDITIONER COMPRESSOR SUPPORT BRACKET - R.R.
• Lower the vehicle.
• Screw the upper screw fastening the starter motor to the gearbox.

5520B14 - STARTER MOTOR - BENCH ASSEMBLY AND REASSEMBLY - WASHING, CHECKING AND, IF REQUIRED, REPLACING COMPONENTS.

Disassembly

• Perform Op. 5520B18 - STARTER MOTOR ELECTROMAGNET - R.R. WITH MOTOR REMOVED
• Position the starter motor in a vice with padded jaws.

1. Remove the two nuts (1a) and the two screws (1b). Remove the rear support (1c).

1. Release brush (1a) (+) and remove the brush carrier support (1b).

(Cont..)