Workshop Manuals Factory service & repair Fiat
Fiat Seicento Factory Service Manual (1998-2010)11 · 70 Bodywork
11 · Body & interior

Reassembly

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Interior trim and upholstery › Reassembly
70 BodyworkReassembly

(Op. 7040H16 continued)

  1. Partly remove hatchback door seal.
Diagram showing the rear hatchback area with a seal labeled 1 being removed from the roof panel frame
  1. Remove roof panel trimming and extract it from hatchback door.
Diagram showing a person removing the roof panel trimming (labeled 1) from the car's interior near the rear hatch

Reassembly

  • Assemble roof panel in car inside.
  • Place seals which were previously partly removed.
  • Position sunroof inner seal.
  • Place rear snap fasteners.
  • Complete with Op. 7055A62 - MOLDING OF A PILLAR, lh or rh - R.R.
  • Complete with Op. 7030H30 - HOOD SLIDING MOTOR PROTECTION - R.R Complete with Op. 7040E10 - ROOF LAMP R.R.
  • Complete with Op. 7065C60 -OUTER REARVIEW MIRROR(one) with manual control - R.R.
  • Complete with Op. 7065C34 - SUNSCREEN VISOR (one), lh or rh - R.R.
  • Complete with Op. 7065C30 - INTERIOR HANDLE (one), lh or rh of passenger compartment - R.R.

Check that all components are correctly assembled.

Be extremely careful to avoid damaging trimming.

7040H30 - FRONT PILLAR TRIMMING (ONE) - R.R.

Removal

  1. Use the tool (1a) for removing front pillar trimming (1b) .
DescriptionCode
1a Removing knife1.878.077.000
Diagram showing a removal knife (1a) being used to separate the front pillar trimming (1b) from the car body

Reassembly

  • Position trimming in its seat and operate a pressure along whole trimming edge.

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.