Workshop Manuals Factory service & repair Fiat
Fiat Seicento Factory Service Manual (1998-2010)11 · 70 Bodywork
11 · Body & interior

Reassembly

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Interior trim and upholstery › Reassembly
70 BodyworkReassembly

(Op. 7040L20 continued)

  1. Withdraw and remove cover of gearbox lever(1a),remove fastener covering panel (1b).
Diagram showing the interior tunnel area with callouts 1a pointing to the gearbox lever cover and 1b pointing to a fastener covering panel below it
  1. Loosen trimming on tunnel fixing screws.
  2. Take off trimming on tunnel.
Diagram showing the centre console tunnel trim with callout 1 pointing to fixing screws at each end and callout 2 pointing to the main trim panel

Reassembly

  • Check that trimming is not damaged.
  • Position trimming on tunnel in seat.
  • Screw fixing screws of tunnel trimming.
  • Assemble gearbox lever guard.
  • Place fastener covering panel.
  • Complete with Op. 7065C72 - FRONT CIGAR LIGHTER SEAT.
  • Complete with Op. 7065C42 - ASHTRAY(ONE), - R.R.

7040L40 - SILL BOARD OF A FRONT DOOR OPENING (ONE), LH OR RH - R.R.

Removal

  1. Open the door, unscrew the fixing screw (1a), remove sill board from fixing clamps.
Diagram showing the lower part of a car door opening with callout 1a pointing to a fixing screw and callout 1b pointing to the sill board

Reassembly

  • Check that sill board is not damaged.
  • Place door sill on fixing clamps again.
  • Screw the screws.

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.