Reassembly
- Make
- Fiat
- Model
- Seicento Factory Service Manual
- Year
- 1998–2010
- Section
- Tailgate › Reassembly
70 BodyworkReassembly
(Op. 7015A10 continued)
- Unloose the striker fixing screws (1a) and adjust the hatchback door position, arrows (1b) show the striker movements (1c).
Reassembly
- Tighten the striker fixing screws to the prescribed torque.
| Attachment | Component | Ø | Value (fromNm) | |
|---|---|---|---|---|
| - | Screw | HATCHBACK DOOR STRIKER | M8 | 1.5 |
7015A14 - HATCHBACK DOOR - CENTRING AND PROFILING ADJUSTMENT- CARRY OUT HINGE AND SEAL POSITIONING ON COMPARTMENT
Removal
- Lift the hatchback door.
- Partly remove the hatchback door seal.
- Remove the snap fasteners (2a) which secure the roof panel trim 2b) in the rear area with proper tool(2c).
| Denomination | Code |
|---|---|
| 2c Removing knife | 1.878.077.000 |
- Properly lower the roof panel trim and position suitable spacers(1b), then unloose hinge fixing screws (1c) and adjust the hatchback door posi-tion, arrows (1d) show the possible hatchback doormovements.
- Tighten the screws to the prescribed torque.
| Attachment | Component | Ø | Value (fromNm) | |
|---|---|---|---|---|
| 1c | Screw | HATCHBACK DOOR HINGES | M8 | 2.5 |
- If necessary operate on rubber pads.
- If necessary adjust the striker position of hatch-back door locking, refer to Op. 7015A10 HATCH-BACK DOOR STRIKER ADJUSTMENT AND POS-SIBLE SEAL POSITIONING.
(Cont..)
Parts & tools for this job For 1998 Fiat Seicento
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Fiat Seicento
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.