A05 Alarm LED does not work
- Make
- Fiat
- Model
- Seicento Factory Service Manual
- Year
- 1998–2010
- Section
- Alarms › A05 Alarm LED does not work
DiagnosisA05 Alarm LED does not work
A05 Alarm LED does not work
When the alarm is operated the check LED does not flash
| Step | Validity | Operation to be performed | Test results | ||
|---|---|---|---|---|---|
| OK | ⚠ | 🔧 | |||
| 1 | CHECK WITH DIAGNOSTIC TOOL | All OK | Problems found | Intervention | |
| Connect the diagnostic tool (Examiner or other tool) to the diagnostic socket. Check in sequence: – no errors in the alarm ECU – all parameters are plausible |
Go to Step 2 | No dialogue between the diagnostic tool and the ECU or receiver. | Restore connection between ECU and diagnostic socket (Wiring diagram E7015 “ALARM”) |
||
| Error detected in ECU or receiver | Continue as shown by the diagnostic tool. | ||||
| 2 | ACTIVE DIAGNOSIS WITH THE DIAGNOSTIC TOOL | All OK | Problems found | Intervention | |
| Perform the following LED operation active test with the diagnostic tool (Examiner or other tool). | Go to Step 3 | LED not working | Restore: – connection between alarm ECU and LED – LED earth (Wiring diagram E7015 “ALARM”) or replace LED OP. PROCEDURE 5580E18 |
||
| 3 | CHECK CORRECT OPERATION | All OK | Problems found | Intervention | |
| Check the fault has been repaired. | End of test | Fault persists | Replace the alarm ECU OP. PROCEDURE 5580E46 | ||
Parts & tools for this job For 1998 Fiat Seicento
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Fiat Seicento
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.