Diagnostic table
- Make
- Fiat
- Model
- Seicento Factory Service Manual
- Year
- 1998–2010
- Section
- Alarms › Diagnostic table
DiagnosisDiagnostic table
Diagnostic table
A10 Alarm door lock does not work
When the alarm is operated, the doors do not lock/unlock at all.
If the door lock does not work even when operated manually, see table P10
| Step | Validity | Operation to be performed | Test results | ||
|---|---|---|---|---|---|
| OK | ⚠ | 🔧 | |||
| 1 | CHECK WITH DIAGNOSTIC TOOL Connect the diagnostic tool (Examiner or other tool) to the diagnostic socket. Check there are no faults. |
All OK Go to Step 2 |
Problems found No dialogue between the diagnostic tool and the ECU or receiver. |
Intervention Restore connection between ECU and diagnostic socket(Wiring diagram E7015 "ALARM") |
|
| Error detected in receiver. | Continue as shown by the diagnostic tool. | ||||
| 2 | CHECKING CORRECT OPERATION Check the fault has been repaired. |
All OK End of test |
Problems found The fault persists |
Intervention Check connection between alarm receiver and door lock ECU or check - and, if required, replace - the receiver OP. PROCEDURE 5580E30 |
|
Parts & tools for this job For 1998 Fiat Seicento
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.