300Tdi Discovery
STEERING
1
REPAIR
POWER STEERING FLUID PIPES
Service repair no - 57.15.21
CAUTION: If any joints are disconnected, it
is essential that open pipe and ports are
plugged to prevent ingress of dirt.
The following procedures must be followed when
refitting fluid pipes:
Power steering pump
1. Remove plugs, place clamp on feed hose.
V8i Steering pump illustrated
2. Push hose onto pump.
3. Hold clamp in position, Tighten to
3 Nm.
4. Fit high pressure union into pump.
5. Hold pipe in correct position. Tighten to
20 Nm.
6. Remove plugs and refit pipes to steering box,
leave fingertight.
7. Tighten to torque: 16mm thread
20 Nm.
14mm thread
15 Nm.
Power steering reservoir
1. Remove plugs and refit pipes and clamps.
2. Tighten clamps to
3 Nm.