Finisher - sill - lower

Refit

1. With assistance, fit bumper valance. Secure bumper valance with scrivets, screws and nuts and bolts.
2. Fit mud flap brackets and secure with screws.
3. Fit rear wheel arch extensions. See this section.
4. Fit both tail lamps. See ELECTRICAL, Repairs.
5. Fit mud flaps. See this section.

FINISHER - SILL - LOWER

Service repair no - 76.43.28

Remove

1. Raise front of vehicle.

WARNING: Support on safety stands.

2. Remove both jacking point covers.
3. Remove 7 scrivits securing finisher.
4. Release and remove finisher from sill.

Refit

1. Clean mating faces of finisher.
2. Position finisher to sill, locate over jacking points and secure with scrivits.
3. Fit jacking point covers.
4. Remove stand(s) and lower vehicle.