Gasket - exhaust manifold - ’k’ series (page 2 of 2)

Refit

1. Clean manifold mating faces.
2. Fit NEW gasket to manifold studs.
3. Fit manifold on studs and tighten nuts in the sequence illustrated to 45 Nm.
4. Connect oxygen sensor multiplug and secure to bracket.
5. Clean pipe flanges.
6. Fit NEW gasket to manifold flange.
7. Raise front pipe and engage flange.
8. Fit manifold to front pipe flange nuts and tighten to 45 Nm.
9. Tighten nuts securing front pipe bracket on IRD unit to 25 Nm.
10. Fit bolts securing front pipe to engine sump and tighten to 25 Nm.
11. Fit underbelly panel. See BODY, Exterior fittings.
12. Fit air filter. See ENGINE MANAGEMENT SYSTEM - MEMS, Repairs.