Freelander System Description and Operation
INSTRUMENTS
88-14
DESCRIPTION AND OPERATION
Rear Fog Lamp
The rear fog lamp warning lamp illuminates when the headlamps are switched on and the rear fog lamp switch is
operated. The lamp is extinguished when the fog lamp switch is operated to turn off the fog lamps or the headlamps
are switched off.
Electronic Traction Control (TC)
The TC warning lamp is illuminated for approximately 4 seconds when the ignition is switched to position II for a bulb
check. When traction control is operating, the TC warning lamp will be illuminated for a minimum of 2 seconds or for
as long as the traction control system is active. The TC warning lamp also illuminates when the ABS ECU detects a
brake system fault which affects traction control. If a fault is detected the lamp will remain permanently illuminated.
The vehicle may still be driven but rectification of the fault should be sought at the earliest opportunity.
Instrument Pack Connector Details
The following tables shows the harness connector face views, pin numbers and input/output information for
connectors C0230 and C0233.
Connector C0233
The following table shows pin inputs/outputs for connector C0233.
Pin No.
Description
Input/Output
1
Door open signal
Input
2
Hazard warning lamps active signal
Input
3
Not used
-
4
Brake warning signal
Input
5
Panel illumination –
Output
6
Panel illumination +
Input
7
Earth
Input
8
Ignition switch position II (ignition) signal
Input
9
Ignition switch position III (crank) signal
Input
10
Ignition charge signal
Input
11
SRS warning signal
Input
12
Oil pressure low signal
Input
13
Air Conditioning request signal
Input
14
Reverse switch signal
Input
15
Alarm active signal
Input
16
LH direction indicator active signal
Input
17
Main beam active signal
Input
18
RH direction indicator active signal
Input