Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Abs control inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Dynamic Stability Control › Abs control inspection
BrakesAbs control inspection · page 1 of 2

3 s .

  1. Turn the ignition switch off.
  2. Jack up the vehicle and support it evenly on safety stands.
  3. Shift to the N position.
  4. Verify that all four wheels rotate.
  5. Rotate the inspected wheels by hand, and verify there is no brake drag.
    • If there is any brake drag, perform regular brake inspection.
    • If there is no brake drag, perform DSC HU/CM operation inspection.

ABS CONTROL INSPECTION

  1. Perform "Preparation".
  2. Connect the M-MDS to the DLC-2.
  3. Set up an active command mode inspection according to the combination of commands below.
BRAKES – Dynamic Stability Control – figure
Fig. 3: Locating DLC-2 Connector
Courtesy of MAZDA MOTORS CORP.

BRAKE PRESSURE RETENTION

Command name Inspected wheels

LF

RF LR RR

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.