Steering angle signal initialization procedure
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Dynamic Stability Control › Steering angle signal initialization procedure
BrakesSteering angle signal initialization procedure
| terminal A) | ||||||
| AF | - | - | - | - | - | - |
| AG | - | - | - | - | - | - |
| AH | - | - | - | - | - | - |
| AI | Lateral-G (signal) | Combined sensor | Continuity | AI-combined sensor connector terminal D | Continuity detected | • Wiring harness (AI- combined sensor connector terminal D) |
| AJ | - | - | - | - | - | - |
| AK | - | - | - | - | - | - |
| AL | - | - | - | - | - | - |
| AM | - | - | - | - | - | - |
| AN | - | - | - | - | - | - |
| AO | - | - | - | - | - | - |
| AP | - | - | - | - | - | - |
| AQ | - | - | - | - | - | - |
| AR | - | - | - | - | - | - |
| AS | - | - | - | - | - | - |
| AT | - | - | - | - | - | - |
STEERING ANGLE SIGNAL INITIALIZATION PROCEDURE
WARNING: If the initialization procedure of the steering angle signal is not completed, the DSC will not operate properly and may cause an accident. Therefore, always perform initialization of the DSC HU/CM steering angle signal to ensure proper DSC operation when any of the following items are performed.
Steering angle sensor replacement
DSC HU/CM replacement
- Inspect the wheel alignment and inflation pressure.
- If there is any malfunction, adjust the applicable part.
- Park the vehicle on level ground.
- Turn the ignition switch off.
- Connect the M-MDS to the DLC-2.
- After the vehicle is identified, select the following items from the initial screen of the M-MDS.
Parts & tools for this job For 2006 Mazda MX-5
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Mazda power steering fluid
As an Amazon Associate we earn from qualifying purchases.