Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Dsc hu/cm inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Dynamic Stability Control › Dsc hu/cm inspection
BrakesDsc hu/cm inspection
BRAKES – Dynamic Stability Control – figure
Fig. 10: Locating DLC-2 Connector
Courtesy of MAZDA MOTORS CORP.

DSC HU/CM INSPECTION

  1. Disconnect the DSC HU/CM connector. (See DSC HU/CM REMOVAL/INSTALLATION .)
  2. Connect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  3. Attach the tester lead to the DSC HU/CM harness side connector, then inspect voltage, continuity or resistance according to the standard (reference value) on REFERENCE VALUE TABLE .

STANDARD (REFERENCE VALUE)

BRAKES – Dynamic Stability Control – figure
Fig. 11: Identifying DSC HU/CM Connector Terminals

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.