Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Dsc control inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Dynamic Stability Control › Dsc control inspection
BrakesDsc control inspection · page 1 of 2

wheel does not rotate. While brake pressure is being reduced and an DSC HU/CM operation click sound is heard, confirm that the wheel rotates.

  • Performing the inspection above determines the following:
  • The DSC HU/CM brake lines are normal.
  • The DSC HU/CM hydraulic system is not significantly abnormal (including DSC HU/CM).
  • The DSC HU/CM internal electrical parts (solenoid, motor and other parts) are normal.
  • The DSC unit and DSC HU/CM output system wiring harnesses (solenoid valve, relay system) are normal.
  • However, the following items cannot be verified.
  • Malfunction with intermittent occurrence of the above items
  • Malfunction of DSC HU/CM input system wiring harnesses and parts
  • Extremely small leaks in the DSC HU/CM internal hydraulic system

DSC CONTROL INSPECTION

  1. Perform "Preparation".
  2. Connect the M-MDS to the DLC-2.
  3. Set up an active command mode inspection according to the combination of commands below.

CAUTION: To protect the DSC HU/CM, the solenoid valve and the pump motor used during active command mode stay on for only 10 s or less each time they are switched on.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.