Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Combined sensor initialization procedure

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Dynamic Stability Control › Combined sensor initialization procedure
BrakesCombined sensor initialization procedure
BRAKES – Dynamic Stability Control – figure
Fig. 16: Tilting Combined Sensor Left And Right
Courtesy of MAZDA MOTORS CORP.

COMBINED SENSOR INITIALIZATION PROCEDURE

WARNING: Unless the initialization procedure of the combined sensor is completed, the DSC will not operate, causing an unexpected accident. Therefore, always perform the initialization procedure to ensure DSC operation if the combined sensor and DSC HU/CM have been removed or replaced.

  1. Inspect the wheel alignment and inflation pressure.
    • If there is any malfunction, adjust the applicable part.
  2. Park the vehicle on level ground.
  3. Turn the ignition switch off.
  4. Connect the M-MDS to the DLC-2.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.