Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)06 · Suspension
06 · Steering & suspension

Rear stabilizer control link inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Rear Suspension › Rear stabilizer control link inspection
SuspensionRear stabilizer control link inspection
SUSPENSION – Rear Suspension – figure
Fig. 29: Precaution For Stabilizer Control Link (2 Of 2)
Courtesy of MAZDA MOTORS CORP.

REAR STABILIZER CONTROL LINK INSPECTION

  1. Remove the stabilizer control link from the vehicle. (See REAR STABILIZER REMOVAL/INSTALLATION .)
  2. Inspect the link for bending or damage. If there is any malfunction, replace the link.
  3. Rotate the ball joint 10 times, and rock the ball joint 10 times.
  4. Measure the ball-joint rotational torque using an Allen wrench and a torque wrench.

Stabilizer control link ball joint rotational torque

0.23-0.47 N.m {2.35-4.79 kgf.cm, 2.04-4.15 in.lbf}

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.