Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)06 · Suspension
06 · Steering & suspension

Toe control link inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Rear Suspension › Toe control link inspection
SuspensionToe control link inspection
SUSPENSION – Rear Suspension – figure
Fig. 19: Installing Toe Control Link Ball Joint
Courtesy of MAZDA MOTORS CORP.

TOE CONTROL LINK INSPECTION

  1. Remove the toe control link from the vehicle. (See TOE CONTROL LINK REMOVAL/INSTALLATION .)
  2. Inspect the lateral link for bending or damage. If there is any malfunction, replace the lateral link.
  3. Inspect the ball joint for looseness. If there is any malfunction, replace the ball joint.
  4. Rotate the ball joint 5 times.
  5. Install the SST to the ball stud, and measure the ball joint rotational torque using a pull scale.

Toe control link ball joint rotational torque 0.3-2.2 N.m {4-22 kgf.cm, 3-19 in.lbf}

Pull scale reading: 3-22 N {0.3-2.2 kgf, 0.7-4.9 lbf}

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.