Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)06 · Suspension
06 · Steering & suspension

Rear trailing link (upper) inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Rear Suspension › Rear trailing link (upper) inspection
SuspensionRear trailing link (upper) inspection
SUSPENSION – Rear Suspension – figure
Fig. 23: Installing Dust Boot To Ball Joint Using SST
Courtesy of MAZDA MOTORS CORP.

REAR TRAILING LINK (UPPER) INSPECTION

  1. Remove the rear trailing link (upper) from the vehicle. (See REAR TRAILING LINK (UPPER) REMOVAL/INSTALLATION .)
  2. Inspect the link or bending or damage. If there is any malfunction, replace the rear trailing link (upper).
  3. Inspect the ball joint for looseness. If there is any malfunction, replace the ball joint.
  4. Rotate the ball joint 5 times.
  5. Measure the ball-joint rotational torque using an Allen wrench and a torque wrench.

Rear trailing link (upper) ball joint rotational torque

0.4-3.3 N.m {5-33 kgf.cm, 4-29 in.lbf}

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.