Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)06 · Suspension
06 · Steering & suspension

Rear crossmember removal/installation

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Rear Suspension › Rear crossmember removal/installation
SuspensionRear crossmember removal/installation
SUSPENSION – Rear Suspension – figure
Fig. 30: Measuring Ball-Joint Rotational Torque Using Allen Wrench & Torque Wrench
Courtesy of MAZDA MOTORS CORP.

REAR CROSSMEMBER REMOVAL/INSTALLATION

CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before operations, remove the ABS wheel-speed sensor (axle side) and move the sensor away from the harnesses.

  1. Remove the exhaust pipe. (See EXHAUST SYSTEM REMOVAL/INSTALLATION [LF] .)
  2. Remove the propeller shaft. (See PROPELLER SHAFT REMOVAL/INSTALLATION .)
  3. Remove the power plant frame. (See TRANSMISSION REMOVAL/INSTALLATION [M15M-D] .) (See TRANSMISSION REMOVAL/INSTALLATION [P66M-D] .) (See AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION [SJ6A-EL] .)
  4. Remove the rear drive shaft. (See REAR DRIVE SHAFT REMOVAL/INSTALLATION .)
  5. Remove the rear differential. (See REAR DIFFERENTIAL REMOVAL/INSTALLATION .)
  6. Remove in the order indicated in the table.
  7. Install in the reverse order of removal.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.