Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)05 · Driveline and axles
05 · Transmission

Oil seal (companion flange) replacement

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Differential › Oil seal (companion flange) replacement
Driveline and axlesOil seal (companion flange) replacement · page 1 of 2
  1. Add differential oil.
  2. After adding the oil, perform the oil level inspection. (See DIFFERENTIAL OIL INSPECTION .)
  3. Install the oil-fill plug with a new washer and tighten.
DRIVELINE/AXLES – Differential – figure
Fig. 7: Tapping In New Oil Seal Using SSTs
Courtesy of MAZDA MOTORS CORP.

Tightening torque

39.2-53.9 N.m {4.00-5.49 kgf.m, 29.0-39.7 ft.lbf}

OIL SEAL (COMPANION FLANGE) REPLACEMENT

  1. Remove the rear differential. (See REAR DIFFERENTIAL REMOVAL/INSTALLATION .)
  2. Replace the oil seal (companion flange) referring to the rear differential disassembly/assembly procedure. (See REAR DIFFERENTIAL DISASSEMBLY .) (See REAR DIFFERENTIAL ASSEMBLY .)
  3. Install the rear differential. (See REAR DIFFERENTIAL REMOVAL/INSTALLATION .)

REAR DIFFERENTIAL REMOVAL/INSTALLATION

CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.