Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)05 · Driveline and axles
05 · Transmission

Bearing cap assembly note

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Differential › Bearing cap assembly note
Driveline and axlesBearing cap assembly note
DRIVELINE/AXLES – Differential – figure
Fig. 46: Measuring Backlash At 4 Locations Around Ring Gear
Courtesy of MAZDA MOTORS CORP.
  1. If the backlash is not within the specification, adjust the gear case component by moving it in the axial direction.

NOTE: When moving the gear case component in the axial direction, replace the adjustment shims. If the adjustment shim on the right side is replaced with one that is 0.05 mm {0.0020 in} thicker, replace the one on the left with one that is 0.05 mm {0.0020 in} thinner.

BEARING CAP ASSEMBLY NOTE

  1. Align the bearing cap alignment marks and assemble the bearing cap with the arrow facing outward.

Tightening torque

72.6-106.9 N.m {7.41-10.91 kgf.m, 53.5-78.84 ft.lbf}

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.