Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)05 · Driveline and axles
05 · Transmission

Drive pinion component assembly note

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Differential › Drive pinion component assembly note
Driveline and axlesDrive pinion component assembly note
DRIVELINE/AXLES – Differential – figure
Fig. 37: Pressing Drive Pinion Into Rear Bearing Using SSTs & Press
Courtesy of MAZDA MOTORS CORP.

DRIVE PINION COMPONENT ASSEMBLY NOTE

Drive Pinion Preload Adjustment

NOTE: Perform preload adjustment with the oil seal uninstalled.

  1. Assemble the following parts to the drive pinion.
    • New collapsible spacer
    • Front bearing
    • New spacer
    • Companion flange
    • New washer
    • New locknut
  2. Turn the serrated part of the drive pinion by hand to seat the bearing.
  3. Tighten the locknut temporarily tightened in Step 1 from the lower limit of the specified tightening torque using the SST , and obtain the specified preload. Record the tightening torque at this time.

Tightening torque

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.