Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)05 · Driveline and axles
05 · Transmission

Rear differential assembly

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Differential › Rear differential assembly
Driveline and axlesRear differential assembly
DRIVELINE/AXLES – Differential – figure
Fig. 24: Removing Bearing Outer Race By Lightly Tapping Edge Of Bearing Outer Race Using
Flathead Screwdriver
Courtesy of MAZDA MOTORS CORP.

REAR DIFFERENTIAL ASSEMBLY

WARNING: The engine stand is equipped with a self-lock mechanism, however, if the rear differential is tilted, the self-lock mechanism could become inoperative. If the rear differential unexpectedly rotates, it could cause injury, therefore do not maintain the rear differential tilted. When turning the rear differential, grasp the rotation handle firmly.

NOTE: Clean away the old silicone sealant before applying the new silicone sealant.

Install the rear cover within 10 min after applying the silicone sealant.

Allow the sealant to set at least 30 min or more after installation before filling the differential with differential oil.

  1. Assemble in the order indicated in Fig. 25 .

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.