Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)05 · Driveline and axles
05 · Transmission

Spacer table

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Differential › Spacer table
Driveline and axlesSpacer table
  1. Add the two (left and right) values obtained by the measurements taken in Step 8 and then divide the total by 2 . From this sum, subtract the sum of the number inscribed on the end of the drive pinion divided by 100 . (If there is no figure inscribed, use 0.) This is the pinion height adjustment value.

Differential pinion height

0.038 mm {0.0015 in} or less

NOTE: When the values obtained by the measurements taken in Step 8, 9 are 0.06 mm {0.0024 in}, 0.04 mm {0.0016 in} and the tip surface of the drive pinion value is 2, the formula is ((0.06+0.04)/2)-(2/100)=0.03. Therefore, assemble a spacer 0.03 mm {0.0012} thicker than the currently assembled one. The thickness settings are in increments of 0.015 mm {0.0006}, so choose one closest in thickness and install.

SPACER TABLE

Identification markThickness (mm {in})Identification markThickness (mm {in})
083.080 {0.1213}293.290 {0.1295}
093.095 {0.1220}303.305 {0.1301}
113.110 {0.1224}323.320 {0.1307}
123.125 {0.1230}333.335 {0.1313}
143.140 {0.1234}353.350 {0.1319}
153.155 {0.1242}363.365 {0.1325}
173.170 {0.1248}383.380 {0.1331}
183.185 {0.1254}393.395 {0.1337}
203.200 {0.1260}413.410 {0.1343}
213.215 {0.1266}423.425 {0.1348}
233.230 {0.1271}443.440 {0.1354}
243.245 {0.1278}453.455 {0.1360}
263.260 {0.1283}473.470 {0.1366}
273.275 {0.1289}--

REAR BEARING ASSEMBLY NOTE

NOTE: Install the spacer with the chamfer on the gear side.

  1. Assemble the spacer selected in the pinion height adjustment to the drive pinion.
  2. Press the drive pinion into the rear bearing using the SSTs and a press.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.