Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)05 · Driveline and axles
05 · Transmission

Oil seal (side gear) replacement

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Differential › Oil seal (side gear) replacement
Driveline and axlesOil seal (side gear) replacement · page 1 of 2
DRIVELINE/AXLES – Differential – figure
Fig. 5: Identifying Oil-Fill Plug Hole And Differential Oil
Courtesy of MAZDA MOTORS CORP.
  1. Install the oil-fill plug with a new washer and tighten.

Tightening torque

39.2-53.9 N.m

{4.00-5.49 kgf.m, 29.0-39.7 ft.lbf}

OIL SEAL (SIDE GEAR) REPLACEMENT

  1. Remove the drain plug and drain the oil.
  2. Install the drain plug with a new washer and tighten.

Tightening torque

39.2-53.9 N.m {4.00-5.49 kgf.m, 29.0-39.7 ft.lbf}

  1. Disconnect the rear drive shaft on the differential side.

(See REAR DRIVE SHAFT, REAR KNUCKLE COMPONENT REMOVAL NOTE .)

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.