Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)05 · Driveline and axles
05 · Transmission

Rear differential disassembly

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Differential › Rear differential disassembly
Driveline and axlesRear differential disassembly
DRIVELINE/AXLES – Differential – figure
Fig. 12: Installing New Drive Shaft Clip To Clip Groove At Top Of Rear Drive Shaft
Courtesy of MAZDA MOTORS CORP.

CAUTION: The sharp edges of the rear drive shaft can slice or puncture the oil seal Be careful not to damage the oil seal when installing the rear drive shaft from the rear differential.

  1. Insert the rear drive shaft into the rear differential with the clip opening facing upward.
  2. After installation, verify that the rear drive shaft is securely held by the clip by pulling the outer ring on the differential side towards the axle.

REAR DIFFERENTIAL DISASSEMBLY

WARNING: The engine stand is equipped with a self-lock mechanism, however, if the rear differential is tilted, the self-lock mechanism could become inoperative. If the rear differential unexpectedly rotates, it could cause injury, therefore do not maintain the rear differential tilted. When turning the rear differential, grasp the rotation handle firmly.

  1. Disassemble in the order indicated in Fig. 13 .

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.