Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)06 · Suspension
06 · Steering & suspension

Rear shock absorber disposal

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Rear Suspension › Rear shock absorber disposal
SuspensionRear shock absorber disposal

REAR SHOCK ABSORBER DISPOSAL

  1. Dispose of the rear shock absorber in the same way as the front shock absorber. (See FRONT SHOCK ABSORBER DISPOSAL .)

REAR LATERAL LINK (UPPER) REMOVAL/INSTALLATION

CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before operations, remove the ABS wheel-speed sensor (axle side) and move the sensor away from the harnesses.

  1. Remove in the order indicated in Fig. 9 .
  2. Install in the reverse order of removal.
  3. Inspect the rear wheel alignment. (See REAR WHEEL ALIGNMENT .)

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.