Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual23 · BR brake system
23 · Brakes

BR brake system: BRAKE BOOSTER - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › BR brake system: BRAKE BOOSTER - Nissan 180SX S13 Workshop Manual
BR brake systemBR brake system: BRAKE BOOSTER - Nissan 180SX S13 Workshop Manual

BR brake system: BRAKE BOOSTER

BRAKE BOOSTER

Removal and Installation 4

‘ i en ¥ / \ 7 { ‘ / aoe \ “ A “ Clevis pin :

x. ee \ 4 Woe VAR, q \ Lay \ a \H i a are 4 a Cf — oa pal a ae hee / q et a ran ae Wo AY “8-11 (0.8 -1.1,5.8 -8.0) “'t ° \ \ wr” Set

(2). Nem (ign, fel)

Brake booster

O}s-14 (0.8 - 1.1, 5.8 - 8.0) SBRA734 Inspection

OPERATING CHECK

@ Depress brake pedal several times with engine off, and check that there is no change in pedal stroke. @ Depress brake pedal, then start engine. If pedal goes down slightly, operation is normal.

SBROOZA

AIRTIGHT CHECK

O.K. N.G. @ Start engine, and stop it after one or two minutes. Depress brake pedal several times slowly. If pedal goes further down the first time and gradually rises after second or third time, booster is airtight. @ Depress brake pedal while engine is running, and stop engine with pedal depressed. If there is no change in pedal stroke after holding pedal down 30 seconds, brake booster is airtight.

OUTPUT ROD LENGTH CHECK

1. Supply brake booster with vacuum of -66.7 kPa (-667 mbar, ~500 mmHg, —19.69 inHg) using a handy vacuum pump.

2. Check output rod length. Specified length:

10.275 - 10.525 mm (0.4045 - 0.4144 in)

SBR2ZB1A

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.